IREAD |
|
| Description: | Read instruction at M : W into M : W |
| Operation: | M : W = PROGRAM[M<<8+W] |
| Flags affected: | none |
| Registers affected: | M, W |
| Sources referenced: | M, W |
| Cycles: | 4 verified |
| Opcode: | |
| Details: | SX Users Manual page # 86 |
| Microchip PIC syntax: | |
| Notes: | |
IREAD - Used to read 12-bit instruction memory. The contents of address (MODE:W) is copied into MODE:W. In other words:
After the IREAD instruction is executed, the high four bits of the addressed location are in MODE and the low eight bits are in W.
by Loren Blaney via Richard Ottosen
Also:
Contrary to some pages of the users guide and the datasheet, IREAD has been confirmed (by Guenther Daubach) to take 4 cycles in turbo mode. +
| file: /Techref/scenix/inst/iread.htm, 3KB, , updated: 2008/1/21 17:11, local time: 2025/1/15 17:53,
18.97.14.81:LOG IN
|
| ©2025 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://www.piclist.com/techref/scenix/inst/iread.htm"> SX Embedded Controller Instruction - IREAD</A> |
| Did you find what you needed? |
|
PICList 2025 contributors:
o List host: MIT, Site host massmind.org, Top posters @none found - Page Editors: James Newton, David Cary, and YOU! * Roman Black of Black Robotics donates from sales of Linistep stepper controller kits. * Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters. * Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated! * Contributors: Richard Seriani, Sr. |
Welcome to www.piclist.com! |
.