please dont rip this site

Automotive Power Systems

Brent Brown says:

I use a regular 7805 in a 12 or 24V automotive environment. My design has a 1N4007 series diode, 10ohm 1W series resistor, 33V 1.3W zener to ground, and 1000uF 35V cap to ground on the input side of the regulator. Adding the resistor here is the key to getting the most from a simple design:-
  1. The resistor limits the peak currents into your zener (during spikes) helping it do its job and ensuring that it doesn't snuff it on the first spike.
  2. The resistor and capacitor make a low pass filter that helps reduce noise into (and out of) your circuit.
  3. Zeners are a little slow perhaps? - then the low pass filter helps here too.

I suggest using a 16V zener for a 12V only application. I also noted that most 7805's have a 35V absolute maximum input voltage rating, but better than some other regs that have been suggested.

My circuit draws about 40-50mA which makes the regulator get warm on a 24V supply so I have a small heatsink on it.

The 1N4007 diode in series with the input prevents damage from reverse supply connection. It also stops the 1000uF cap from discharging if the supply voltage falls (eg. engine cranking), so if your circuit doesn't draw too much you have a short term UPS!

See also:

Questions:


file: /Techref/power/autos.htm, 2KB, , updated: 2017/7/13 14:11, local time: 2017/11/24 17:50,
TOP NEW HELP FIND: 
54.156.92.243:LOG IN

 ©2017 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE! / 

<A HREF="http://www.piclist.com/techref/power/autos.htm"> Automotive power systems</A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?

  PICList 2017 contributors:
o List host: MIT, Site host massmind.org, Top posters @20171124 RussellMc, Van Horn, David, James Cameron, Sean Breheny, alan.b.pearce, IVP, Neil, David C Brown, Bob Blick, Denny Esterline,
* Page Editors: James Newton, David Cary, and YOU!
* Roman Black of Black Robotics donates from sales of Linistep stepper controller kits.
* Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters.
* Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated!
* Contributors: Richard Seriani, Sr.
 

Welcome to www.piclist.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .