Gordon Varney says:
I recommend using the X-10 part number PL-513, you can down load the manual from http://www.x10.com . A PIC will interface real easy with the PL-513. The manual will give you the diagrams and parts needed to interface. The manual will also describe the algorithm to send X-10 code over the power line. This module is very safe and easy to use.
http://www.cix.co.uk/~pplunkett/x10.htm (cached 20010530114658) 16C54 based X-10 Compatible Appliance Module
Heinz Czychun says:
http://www.national.com/an/AN/AN-146.pdf is an old appnote for sending FM through the AC line but it specifies line signal xformers. I used these with appropriate caps to tune to the x10 signal frequency.
The part numbers have changed since the appnote. The parts I ordered many years ago were TOKO RAN 10A6729 for the Tx xformer, and RAN 10A6845 for the Rx xformer, they may gave changed since then?
There's also an x10 module TW523 that provides logic level x10 RX, TX and zero crossing and a PIC based Weeder Technologies Home Automation Controller (http://www.weedtech.com/wthac.html) that allows serial/ASCII control of the TW523.
|file: /Techref/microchip/io/x10s.htm, 2KB, , updated: 2003/3/2 08:51, local time: 2018/11/19 02:18,
|©2018 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.piclist.com/techref/microchip/io/x10s.htm"> PIC Microcontoller Input / Ouput Methods for X10</A>
|Did you find what you needed?|
PICList 2018 contributors:
o List host: MIT, Site host massmind.org, Top posters @20181119 RussellMc, Van Horn, David, Sean Breheny, David C Brown, Isaac M. Bavaresco, Bob Blick, Neil, Manu Abraham, John Gardner, AB Pearce - UKRI STFC,
* Page Editors: James Newton, David Cary, and YOU!
* Roman Black of Black Robotics donates from sales of Linistep stepper controller kits.
* Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters.
* Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated!
* Contributors: Richard Seriani, Sr.
Welcome to www.piclist.com!