please dont rip this site

Language Pcl LJ1903

DRAWING RECTANGLES USING EA

    
     The commands to draw rectangles in HP-GL/2 are EA ,
     Edge Rectangle Absolute , and ER , Edge Rectangle
     Relative. To use these commands, the printer uses the
     current pen location for one corner and you give the
     coordinates for the diagonally opposite corner. This
     example uses EA to draw the rectangle.  For more
     information see the PCL 5 Printer Language Technical
     Reference Manual.
     
     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT.
     
     
     EcE                           Resets the printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes HP-GL/2 mode.
     
     SP1;                          Selects pen number 1,
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     PA10,10;                      Specifies absolute
                                   plotting, then moves to
                                   (10,10).
     
     EA2500,1500;                  Draws the outline of a
                                   rectangle with the lower
                                   left corner being the
                                   current pen location,
                                   (10,10), and the upper
                                   right corner being
                                   (2500,1500).
     
     Ec%0A                         Enters PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.
     
     
     
            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.
     


file: /Techref/language/pcl/lj1903.asc, 2KB, , updated: 1993/11/15 17:16, local time: 2017/10/22 01:41,
TOP NEW HELP FIND: 
54.81.210.99:LOG IN

 ©2017 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE! / 

<A HREF="http://www.piclist.com/techref/language/pcl/lj1903.asc"> language pcl lj1903</A>

Did you find what you needed?

  PICList 2017 contributors:
o List host: MIT, Site host massmind.org, Top posters @20171022 RussellMc, Van Horn, David, James Cameron, Sean Breheny, IVP, alan.b.pearce, Neil, David C Brown, Bob Blick, Denny Esterline,
* Page Editors: James Newton, David Cary, and YOU!
* Roman Black of Black Robotics donates from sales of Linistep stepper controller kits.
* Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters.
* Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated!
* Contributors: Richard Seriani, Sr.
 

Welcome to www.piclist.com!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .