DRAWING LINES IN HP-GL/2 For more information see the PCL5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] Esc] in DOS EDIT EcE Resets the Printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes printer. SP1; Selects pen number 1 (Black). Even though there is no physical pen, the SP command must be used to enable printing. PA0,0; Begins absolute plotting from coordinate (0,0). PD2500,0,0,1500,0,0; Specifies the pen down and draw lines between the points. Ec%0A Enters the PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.
|file: /Techref/language/pcl/lj1887.asc, 1KB, , updated: 1993/11/15 16:14, local time: 2018/2/24 10:00,
|©2018 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.piclist.com/techref/language/pcl/lj1887.asc"> language pcl lj1887</A>
|Did you find what you needed?|
PICList 2018 contributors:
o List host: MIT, Site host massmind.org, Top posters @20180224 RussellMc, Sean Breheny, Van Horn, David, David C Brown, Isaac M. Bavaresco, Darron Black, Harold Hallikainen, alan.b.pearce, Bob Blick, Brent Brown,
* Page Editors: James Newton, David Cary, and YOU!
* Roman Black of Black Robotics donates from sales of Linistep stepper controller kits.
* Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters.
* Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated!
* Contributors: Richard Seriani, Sr.
Welcome to www.piclist.com!