Language Pcl LJ2079.ASC

USING  THE RELATIVE CHARACTER SIZE ( SR ) COMMAND

     
     The Relative Character Size ( SR ) command, specifies
     the size of labeling characters as a percentage of the
     distance between P1 and P2.  For more information see
     the PCL 5 Printer Language Technical Reference Manual.
     The syntax for this command is as follows:
     
     SR width, height; or SI;
     
     LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT.
     
     
     EcE                           Resets the printer.
     
     Ec%0B                         Enters HP-GL/2 mode.
     
     IN;                           Initializes HP-GL/2 mode.
     
     SP1;                          Selects pen number 1,
                                   (black). Even though
                                   there is no physical pen,
                                   the SP command must be
                                   used to enable printing.
     
     IP-6956,-4388,6956,4388;      Moves P1 to (-6956,-
                                   4388), and P2 to
                                   (6956,4388).
     
     DT@;                          Defines the label
                                   terminator as the "@"
                                   character.
     
     SR;PA0,2700;LBRELATIVE LABEL SIZE@;     Defaults the
                                   character size as a
                                   percentage of the P1/P2
                                   rectangle, and moves the
                                   pen to (0,2700); prints
                                   "RELATIVE LABEL SIZE".
     
     IP0,0,5500,5500;PA0,2000;     Moves P1 to (0,0) and P2
                                   to (5500,5500); moves the
                                   pen to (0,2000).
     
     LBNEW P1 AND P2 CHANGE LABEL SIZE@;     Prints "NEW P1
                                   AND P2 CHANGE LABEL
                                   SIZE".
     
     PA0,1000;SR2.5,2.5;           Moves to (0,1000) and
                                   sets the character size
                                   to 2.5% by 2.5% of the
                                   P1/P2 rectangle.
     
     LBNEW SR INSTRUCTION@;CP;     Prints "NEW SR
                                   INSTRUCTION" and sends a
                                   CP for Carriage
                                   Return/Line Feed.
     
     LBCHANGES LABEL SIZE@;        Prints "CHANGES LABEL
                                   SIZE."
     
     Ec%0A                         Enters PCL mode.
     
     EcE                           Sends a reset to end the
                                   job and eject the page.
     


            Copyright  Hewlett-Packard Co. 1993
   The information contained herein is subject to change
                      without notice.
   Hewlett-Packard shall not be liable for incidental or
  consequential damages in connection with the use of this
                         material.

PICList 2024 contributors: o List host: MIT, Site host massmind.org, Top posters @none found - Page Editors: James Newton, David Cary, and YOU! * Roman Black of Black Robotics donates from sales of Linistep stepper controller kits. * Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters. * Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated! * Contributors: Richard Seriani, Sr.

  .