Also see: other methods if figuring out stepper motor wiring
Rodney McLatchy says: "...attach A+ and A- to 2 probes of the scope common to ground, and spin the shaft by hand. On the screen they should come out 180degee. out of phase. If one phase is backwards they would look the same. Or if I mixed an A with a B, 90degees out."
See also:
NEW! Roman Black's Linistep 1. stepper controller kit Proceeds support PICList.com
file: /Techref/io/stepper/wiresscope.htm, 1KB, , updated: 2011/2/25 16:53, local time: 2025/2/10 22:02,
18.97.9.168:LOG IN
|
©2025 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://www.piclist.com/Techref/io/stepper/wiresscope.htm"> Stepper Motor wiring with an Oscilloscope</A> |
Did you find what you needed? |
![]() o List host: MIT, Site host massmind.org, Top posters @none found - Page Editors: James Newton, David Cary, and YOU! * Roman Black of Black Robotics donates from sales of Linistep stepper controller kits. * Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters. * Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated! * Contributors: Richard Seriani, Sr. |
Welcome to www.piclist.com! |
.