CU-50 RTD resistance chart?
speffTakeThisOuT@spamBeGoneinterlog.com email (remove spam text)
Quoting William Couture <gmail.com>:bcouture
> Both those charts have different thermal coefficients, and have different
> "zero" scales -- the 10R is 10R at 25C, the 100R is 100R at 0C.
> the 10R chart multiplied by 5.5356 is closer, but it's strange that a real
> chart can't be found anywhere...
They're all real- it's just that there is no international standard for Cu RTDs that I know of. You have not mentioned why you want this- obviously if you are buying the sensor you are going to want to go to the manufacturer for the data. If you are trying to make a general purpose indicator or controller.. you might want to use this (assuming the reference temperature of 25 C is appropriate..)
Again, scale the numbers appropriately (5:1 in this case). Anything that's
within a degree or two C at the extremes is probably better than the sensor
Where exactly did you run into a 50 ohm copper RTD?
-- http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
In reply to: <CAGLXasenf+Wx_evwxaj10dxEHSQHChvPkdJ6aBWK8kEt6JTV7A@mail.gmail.com>
See also: www.piclist.com/techref/index.htm?key=rtd+resistance+chart
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the