piclist 2009\06\25\030353a >
Thread: odyssey - can't set/unset (+/-) pvcd
www.piclist.com/techref/microchip/devices.htm?key=pic
picon face BY : Csanyi Pal email (remove spam text)



Hi,

I'm trying to use odyssey for PIC programming on the parallel port.
http://www.desert.cx/odyssey/

The new website for odyssey is break down today..
http://vasco.gforge.enseeiht.fr/index.php?article=Odyssey.html

My system is Debian GNU/Linux Lenny with kernel: 2.6.26-2-686.

I did:
sudo rmmod ppdev lp parport_pc parport

sudo odyssey test

and get:
Current Status:
Pwr     = 1    Vpp    = 1    Clk = 1    LVP = 0
DataOut = 0    DataIn = 1
th = 20ns  tl = 20ns

The problem is that that I can't to neither set  nor unset signals:  
p = power  v = vpp  c = clk   d = data (out)
because I get always the abowe mentioned Current Status.

If I load kernel modules with:
sudo modprobe parport_pc

and run

sudo odyssey test

then can I set and unset signals.

Why must I load the parport_pc and parport modules to can set/unset
signals from odyssey because I can read in the setup.txt file this:

"..
directpp - Accesses the parallel port using direct I/O.
Setting up:
 Make sure that no parport drivers are loaded at all. That includes
 parport and parport_pc.
.."

I tried to wrote a mail to maintainers:
spamBeGonepierre.gaufilletTakeThisOuTspam@spam@magic.fr
grouchoRemoveMEspamEraseMElugmen.org.ar

but get no answers at all.

Any advices will be appreciated!

--
Regards, Paul Csanyi
http://www.freewebs.com/csanyi-pal/index.htm

<87iqikg5h8.fsf@debian-asztal.csanyi-pal.info> 7bit

See also: www.piclist.com/techref/microchip/devices.htm?key=pic
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) odyssey - can't set/unset (+/-) pvcd

month overview.

new search...