Single Layer Autorouter?
Bob Blick email (remove spam text)
> Hey all, does anyone know of a single layer autorouter for PCB design?
What you do is set the cost of one of the sides higher, so it minimizes
routing on one side. Then for the traces you must have on the expensive
side, adjust the routes so you can use jumper wires.
Also you can selectively use keepouts on the expensive side.
In reply to: <firstname.lastname@example.org>
See also: www.piclist.com/techref/pcbs.htm?key=autoroute
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the