piclist 2008\07\20\072147a >
Thread: SX48 proto board and Pull ups
www.piclist.com/techref/ubicom/devices.htm?key=sx48
BY : RS_Jim


In SX Microcontrollers, SX/B Compiler and SX-Key Tool, RS_Jim wrote:

Good Sunday Morning,
Using the snipit of code I posted the other day, I run the program fine under SX-Sim.  It does as I expect.  However, when I run it on a protoboard, I get all 0 all the time on RE.  I grabbed a brand new proto board, after implementing strict ESD measures and installed a single 270 ohm resistor from RE 5 to VSS.  I would expect to see all 1 except a 0 in RE.5. Where do I go from here?
Jim
---------- End of Message ----------

You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=279839#m280348
Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com
The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2008 (http://www.dotNetBB.com)

seeking: aids africa three

<676f1324fdf946e1a863c80bf2b89d59@ZEUS>

See also: www.piclist.com/techref/ubicom/devices.htm?key=sx48
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) SX48 proto board and Pull ups

month overview.

new search...