piclist 2003\03\02\181409a >
Thread: IC-Prog and eeprom programming
www.piclist.com/techref/microchip/devprogs.htm?key=programming
flavicon
face BY : Vincent Blok email (remove spam text)



Hello,

I am using ic-prog to upload my hex file to my 16F877a with a JDM programmer. The thing is that every time i reload my hex file it reads in the program code and seems to read in the eeprom as all 0xFF's. Then when i burn the chip my old eeprom settings are all ereased! Is there a way to prevent this from happening so that only my program code will be burnt and the eeprom is left unchanged?

Second i would like to know if there is a way (maybe with a shortcut key i am not aware of) to do a integrated "reload and burn" which reloads the last hex file and burns it again because now i have to select my file again to have it's contents updated in icprog and then hit "burn". This is not a real problem, i was just wondering if it is possible?

Thanks,

Vincent Blok
The Netherlands


--
http://www.piclist.com hint: To leave the PICList
piclist-unsubscribe-requestEraseMEspammitvma.mit.edu>
<001e01c2e10f$d4d65310$0201a8c0@Bigtower> quoted-printable

See also: www.piclist.com/techref/microchip/devprogs.htm?key=programming
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) IC-Prog and eeprom programming

month overview.

new search...