Sean Breheny email (remove spam text)
I'm looking for info on how to use the AVR's SPI hardware in slave mode.
Specifically, how do you begin a transfer? How do you tell it to "reset"
and receive bit 0 on the next clock transition? How do you determine when
it has finished receiving 8 bits? The info in the datasheet (I'm using
the AT90S8535) is geared toward master mode and it doesn't seem to
clearly state how this would work in slave mode.
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads
See also: www.piclist.com/techref/io/serial/spis.htm?key=spi
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the