piclist 2002\12\12\154416a >
Thread: Cutouts for LCD Displays
www.piclist.com/techref/lcds.htm?key=lcd
picon face BY : Spehro Pefhany email (remove spam text)



At 03:33 PM 12/12/02 -0500, you wrote:
>>If you do this, be careful as some drill presses have the chuck held
>>in place by a taper- just friction- and side loads can make it come
>>loose, with undesirable consequences.
>
>Mine is mounted that way, and twice it has fallen out... but never when I
>was actually cutting a box.   Though I did jam it in there pretty solidly....

A little dab of Loctite can make sure, but then the opposite problem
could occur. ;-)

Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the reward"
.....speffRemoveMEspamEraseMEinterlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com

--
http://www.piclist.com hint: To leave the PICList
RemoveMEpiclist-unsubscribe-requestspamspammitvma.mit.edu>
<5.1.1.6.2.20021212154124.027709d0@mail.interlog.com>

In reply to: <4.3.2.7.2.20021212153151.00c90100@evita2.cs.fredonia.edu>
See also: www.piclist.com/techref/lcds.htm?key=lcd
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) Cutouts for LCD Displays

month overview.

new search...