piclist 2002\12\12\152752a >
Thread: Cutouts for LCD Displays
picon face BY : Spehro Pefhany email (remove spam text)

At 02:56 PM 12/12/02 -0500, you wrote:
>I have mounted a piece of wood on the bed of my table top drill press.  I
>use a 1/8" router bit in the drill press.

<rest of good stuff snipped>

If you do this, be careful as some drill presses have the chuck held
in place by a taper- just friction- and side loads can make it come
loose, with undesirable consequences.

Best regards,

Spehro Pefhany --"it's the network..."            "The Journey is the reward"
TakeThisOuTspeff@spam@spamspaminterlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com

http://www.piclist.com hint: To leave the PICList

In reply to: <>
See also: www.piclist.com/techref/lcds.htm?key=lcd
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) Cutouts for LCD Displays

month overview.

new search...