MPSIM 8.10 (6.10.00 version) vs. 7.70.40
Spehro Pefhany email (remove spam text)
Simulating a PIC16F676, some of the SFRs such as INTCON don't seem to
simulate properly, using MPSIM 8.10 under MPLAB 6.10.00 (they
remain at 0x00 despite writes to them).
OTOH MPSIM 7.70.40 under MPLAB 5.70.40 works properly for this part.
Any suggestions (other than the obvious one of not using 6.10)?
Spehro Pefhany --"it's the network..." "The Journey is the reward"
interlog.com Info for manufacturers: speffhttp://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads
See also: www.piclist.com/techref/microchip/devices.htm?key=pic
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the