Spehro Pefhany email (remove spam text)
At 01:05 PM 12/7/02 -0500, you wrote:
>Atmel has an app note on this (called "high endurance" something
>or another). This works, but a better way is to go through the entire
>EEPROM, then start again at the beginning.
I think there are some notes about special refreshing procedures if your
required endurance exceeds 10% of the rated numbers.
You could always queue the numbers in RAM and write them once every 10
minutes (say). The only difference would be in case of a power failure you'd
lose a bit more data than otherwise.
Spehro Pefhany --"it's the network..." "The Journey is the reward"
interlog.com Info for manufacturers: speffhttp://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
http://www.piclist.com hint: To leave the PICList
In reply to: <3DF23863.601B63E2@earthlink.net>
See also: www.piclist.com/techref/mems.htm?key=eeprom
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the