Is it possible to adjust internal osc to 3.6864MHz?
You don't need to mess with oscal, nor use a specific clock, assuming
you're using bit-bashed RS232.
It is not particularly difficult to auto-detect the baudrate of an
incoming signal, as long as you know what initial character you are
expecting (a zero byte is best, as it has maximal length), and then
adjust the timing of your tx/rx code to compensate.
On Thu, 6 Dec 2001 16:15:04 +1100, you wrote:
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email mitvma.mit.edu with SET PICList DIGEST in the body listserv
In reply to: <19654A3C5F08454DB653AD1669EF67DB20BE57@nefexch1>
See also: www.piclist.com/techref/microchip/time.htm?key=osc
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the