LCD panel init problems
Peter L. Peres email (remove spam text)
Do you use the prescribed software init sequence ? If not, then you need
it. Also make sure that you do not send data too fast. I have had garble
happen when I sent data too fast in an application where the ready bit was
not read back. The fast data combined to change the mode of the LCD
So when I have this problem, first I slow the data down considerably, and
if that does not help, then I start troubleshooting elsewhere.
hope this helps,
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email mitvma.mit.edu with SET PICList DIGEST in the body listserv
See also: www.piclist.com/techref/lcds.htm?key=lcd
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the