piclist 2001\10\31\183827a >
Thread: LCD panel init problems
www.piclist.com/techref/lcds.htm?key=lcd
flavicon
face BY : David VanHorn email (remove spam text)



At 05:22 PM 10/31/01 -0600, Lawrence Lile wrote:
>Boy, I have the same problem.  A real showstopper when you go to demonstrate
>a prototype.  Usinf SEETRON 2X16 character LCD's.  Anybody got an idea?

This is symptomatic of improper timing of signals.
Can you toss some nops into the lowest level routines, and stretch out the
setup and hold times?

It could be bounce and ringing on the cable.
A quick check would be to add a series network of 0.1uF and 120 ohm
resistors to each signal line.
This won't be a perfect match, but it's hard to measure cable impedance
through email :)

--
Dave's Engineering Page: http://www.dvanhorn.org

Got a need to read Bar codes?  http://www.barcodechip.com
Bi-directional read of UPC-A, UPC-E, EAN-8, EAN-13, JAN, and Bookland, with
two or five digit supplemental codes, in an 8 pin chip, with NO external parts.

--
http://www.piclist.com hint: The PICList is archived three different
ways.  See http://www.piclist.com/#archives for details.


<4.3.2.7.2.20011030183523.0345d990@mail.cedar.net>

In reply to: <002a01c16262$f2d44840$3501010a@toastmaster.com>
See also: www.piclist.com/techref/lcds.htm?key=lcd
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) LCD panel init problems

month overview.

new search...