How to reset PIC (without WDT enabled) by the software?
Mike Mansheim email (remove spam text)
> I need a possibility to reset the PIC by the software (after receiving
> a special command via serial interface). The design does not use WDT
> (otherwise it would be enough to stop executing the CLRWDT commands).
This was recently discussed, where I mentioned I was causing a reset
using the watchdog. It was suggested that such a reset was unnecessary,
and that 'goto 0' with the registers properly set up was all that was
required. Might that work for you?
http://www.piclist.com#nomail Going offline? Don't AutoReply us!
email mitvma.mit.edu with SET PICList DIGEST in the body listserv
See also: www.piclist.com/techref/microchip/devices.htm?key=pic
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the