piclist 2001\07\31\182431a >
Thread: How to print words on enclosure box?
www.piclist.com/techref/index.htm?key=how+print+words
flavicon
face BY : Mike Kendall email (remove spam text)



Years ago, I used a spray lacquer to cover up my artwork on a power supply
project.  It was very nice and neat looking, but I could not resist the
temptation to clean it with the best solvent I had at my disposal,
tri-clorofloroethane, it dissolved the lacquer and destroyed the artwork.
This solvent is very common in electronics and called tri-chlor.  I'm not
sure what else will dissolve the lacquer, but be careful of solvents and
lacquer coatings over electronic project artwork.
Regards,
Mike
{Original Message removed}
<009901c119e6$63b89c20$0101a8c0@pavilion> 7bit

See also: www.piclist.com/techref/index.htm?key=how+print+words
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) How to print words on enclosure box?

month overview.

new search...