David VanHorn email (remove spam text)
>Is there any way to know if the signal is too weak? What is meant by
Relative amplitude between the low and high tones.
You need a spectrum analyzer to see that.
>The signal at the transformer secondary has an amplitude of around 40 mV
>peak. Is this considered fine?
Should be ok, you need to check the chip spec though.
Dave's Engineering Page: http://www.dvanhorn.org
Where's dave? http://www.findu.com/cgi-bin/find.cgi?kc6ete-9
http://www.piclist.com hint: PICList Posts must start with ONE topic:
[PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads
In reply to: <F169mKgWAFZMUyM2uzq00011cb9@hotmail.com>
See also: www.piclist.com/techref/pots/dtmf.htm?key=dtmf
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the