Having trouble with LM1881 / NTSC sync separator
Bob Ammerman email (remove spam text)
>The CRO signal may be missleading, you need to check if the is set to
ALTernate or CHOP. You need >CHOP to check that the video is in phase, ALT
will always show the two signals in sync as it triggers for >each chanel.
Some CRO's chose between these modes depending on the trace sweep speed.
Only if the scope is set to 'NORM' trigger. My scope lets me trigger on a
single channel and then display both channels on that timebase (using either
ALT or CHOP)
(contract development of high performance, high function, low-level
http://www.piclist.com hint: The PICList is archived three different
ways. See http://www.piclist.com/#archives for details.
See also: www.piclist.com/techref/displays.htm?key=ntsc
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the