'F87xx Config Programming
pandersn.....@KILLspamidir.net email (remove spam text)
I am using the 16F873 and program the config fully with my MPLAB software
and the PICSTART PLUS. In *.inc file contains all the names of the various
config bits. I found that the low voltage name in the inc file is LVE
(rather than that listed which I don't recall...LVF, LVP?). Seems to work
fine. I haven't looked at the 872? but if it is like the 873, remember to
turn off the A/D converter since it is set ON at POR unless configured OFF.
Also, turn LVE OFF.
Hope that helps.
On Wednesday, June 07, 2000 12:05 AM, Tony Nixon
[SMTP:ENG.MONASH.EDU.AU] wrote: Tony.Nixon
> Heinz Czychun wrote:
> > Hi All,
> > Now that I've gotten one of the new Flash PIC chips (16F872), I
> > wanted to program it. As indicated by an email by Jim Robertson, my
> > and MacPic will program the 'F872, by selecting the 'F84 as the chip to
> > programmed. But it cannot program all the bits in the config register,
> > I would like to put it into HVP mode to liberate RB3. So I looked at
See also: www.piclist.com/techref/microchip/devprogs.htm?key=programming
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the