David VanHorn email (remove spam text)
-----BEGIN PGP SIGNED MESSAGE-----
At 11:38 AM 6/6/00 -0700, Peter Schultz wrote:
>You absolutely right, it will not save a bad layout, but that is what people
>We have oscillation on this board, let put more filtering, isn't that sounds
Worst is where I see them added! Like putting a cap to ground (some
arbitrary point in the ground system) from a signal line, to "smooth it
out"... Grrr. Now the driver needs much more current on each transition,
and the problem is worse.
Resistance in series solves this problem, but it's not so convenient to
implement usually. (Tip: high speed clock lines should always have a
resistor at the source. Even if later you choose the value to be zero,
though likely 100 ohms will be better)
Are you an ISP? Tired of spam?
http://www.spamwhack.com A pre-emptive strike against spam!
Where's Dave? http://www.findu.com/cgi-bin/find.cgi?kc6ete-9
-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 6.5.2 for non-commercial use <http://www.pgp.com>
-----END PGP SIGNATURE-----
In reply to: <A60A7E4FA193D211A6720008C7B131BF03504FAB@nt3.minimed.com>
See also: www.piclist.com/techref/logic/dsps.htm?key=filter
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the