[EE] 24-bit A/D. Are We in the Twilite Zone Here?
Wagner Lipnharski email (remove spam text)
Even a good polypropylene or polyester cap can generate noise if you are
out of luck.
A good way to check those guys is increase the op-amp gain to the max
rail limits and check the noise generation, so you could play with
components until you find out the ones that would benefit you with low
noise, then reduce op-amp gain to the correct gain.
I already made few op-amps high impedance gain, that the input coupling
cap + resistor could not touch the circuit board... yup, just in the
air, the best isolator I know.
Dan Michaels wrote:
See also: www.piclist.com/techref/io/atod.htm?key=a%2Fd
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the