Peter L. Peres email (remove spam text)
> 4 + 2 chips
Can you give me the chip numbers ?
The 14 pin pin-out is easy, it's pretty much standard for most graphics
displays, it's the timing details that are killing.
Power is usually +5V and -28V. If the FEL power is on board the power may
be generated locally.
If at least one of the chips is a RAM or a SED controller, you may have
paralell access buffered display. Anything else and you have to bit-bang
graphics into it at display refresh speed. Mine is of the second kind.
The C program I have hacked up is just a test program that lights up a
frame around my display when hooked up to the parallel port.
I'll make a package with my interface schematic and send it this week.
In reply to: <199811091450.GAA10828@mail1.bctel.ca>
See also: www.piclist.com/techref/lcds.htm?key=lcd
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the