On some 900 MHz equipment I've seen, they use tuning stubs that
toward the end of the stub are broken by lots of thin lines running
across the width of the stub.
On test just run your soldering iron (to bridge the lines) as far as
You could do the same on your cap,
not much good on a 100000 piece run, but for a preproduction run ?
Peter Schultz wrote:
email: her.forthnet.gr phone: + 3081 380534 cousens
snailmail: Folia, Agia Fotini, Karteros, Heraklion Crete, Greece.
Is it true? that they have, on the new version of windows
managed to increase the MTBF from 95 to 98 minutes
(Thats why they called it 95)
See also: www.piclist.com/techref/pcbs.htm?key=pcb
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the