Getting started with PIC - need help!
Luca Favaro email (remove spam text)
Hi, I need some help from all of you PIC expert!
I've been reading a lot of stuff on the Internet about the PIC processor
and I think now I'm (almost) ready to start building some project,
though there are still some basic concepts that I still don't
First of all I want to build my own programmer, unfortunately on the
Internet there are too many design and I can't make up my mind. I'm now
oriented to build the "programmer 2" shown in this site:
Does anybody have tried it? Any comments?
I'm planning to build some project using PIC 16CXXX but also the
12CXX... by the way, why there is no mention on the latter one on the
FAQ? is it out of production?
I'm planning to use assembler to program the PIC but again there are too
many options out there! I would like to use some freeware pakage.... do
you have any suggestion?
As far as loading the software onto the PIC, I'm assuming that there is
a thight relationship between the programmer board and and the
programmer software. Which downloader shoud I use?
And now I need some more help on choosing the PIC... I see there is only
one model that is EEPROM (the 16C84), all the other are EPROM which I
assume need to be UV erased. What do PIC hobbist normally use? if I
remember right it takes quite a while to erase an EPROM and also the
number of times it can be erased is very limited... am I right?
To summarize... I would like to work on some very simple project using
the PIC processsor but I'm kind of afraid because I don't know where to
Thanks for your time... sorry for the XXL e-mail
See also: www.piclist.com/techref/microchip/begin.htm?key=pic
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the