piclist 1998\10\01\124044a >
Thread: Power Line Interface
www.piclist.com/techref/power.htm?key=power
flavicon
face BY : WIL REEDER email (remove spam text)



There is an X10 device called a TW23 power line interface (about $25) that
will give you access to the zero crossing for sending & receiving. I
recently saw a circuit using a opto isolator to pick-off the zero crossing;
this signal then could be used to gate your trans/ rec. The tw23 is a much
better bet.
Good luck

Wil Reeder
KILLspamteachtechRemoveMEspam@spam@bc.sympatico.ca

----------
> From: Malcolm N. Haynes Jr. <spam_OUTmalcolm@spam@spamCEW.WWIA.NET>
> To: EraseMEPICLISTspam_OUTspamMITVMA.MIT.EDU
> Subject: Power Line Interface
> Date: Wednesday, September 30, 1998 6:10 AM
>
> My name Is Malcolm and I am working on a home automation project.
Currently I am building a transmitter to place X10 signals onto the 120VAC
60Hz house mains. The signal transmitted is a +5V/120kHz square wave. The
timing is on the zero crossings of the AC line. I need to block the 60Hz
signal from the output while allowing it to pass for the zero crossing and
power supply do you have any ideas.
>
> Thanks in advance for your help.
>
> Malcolm

<199810011634.JAA03429@nfs1.bctel.ca> 7bit

See also: www.piclist.com/techref/power.htm?key=power
Reply You must be a member of the piclist mailing list (not only a www.piclist.com member) to post to the piclist. This form requires JavaScript and a browser/email client that can handle form mailto: posts.
Subject (change) Power Line Interface

month overview.

new search...