Andy Kunz email (remove spam text)
At 01:18 PM 9/8/97 +0200, you wrote:
> I had like to drive a plotter which uses RS232 protocol. When using
>Hyperterminal, things are working fine, except that it sends ASCII. I am
>using: Send text file. Is there any other soft, or perhaps in Hypert.,
>to drive my plotter like Hyperterminal does, but with binary transfer?
>Thanks a lot.
I presume you have a file with the plot commands in it.
C:> COPY filename COM1 /B
The /B is the key - it goes out in pure binary then.
Andy Kunz - Montana Design - 409 S 6th St - Phillipsburg, NJ 08865
Hardware & Software for Industry & R/C Hobbies
"Go fast, turn right, and keep the wet side down!"
In reply to: <3413DF0F.2781E494@sdm.bel.alcatel.be>
See also: www.piclist.com/techref/io/serials.htm?key=rs232
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the