John Payson email (remove spam text)
> One question: If I end up having to solder parts onto both sides of the
> board, how do I keep the ones on the bottom from falling off? Are all SMT
> parts the same height, so that the oven tray will hold them in place until
> they cool off? Any suggestions are welcome.
Glue [or other similar adhesive]. Actually it's recommended for the parts
on both sides of the board, since otherwise parts might move slightly when
the board is put into or removed from the oven.
In reply to: <firstname.lastname@example.org> from "Andrew Russell Morris" at Sep 6, 97 09:29:24 am
See also: www.piclist.com/techref/pcbs.htm?key=smt
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the