Parallax: PASM , LCALL, CALL etc.
Brad Mitchell email (remove spam text)
I'm just learning this stuff, last assembler I used was
on a z80 with my timex sinclair.. before that a pdp-11..
1. LCALL in parallax's assembler states that this is only
useful for the 56 and 57. I assume that this is because of the
the size of the 54 eprom, prohibits an 11 bit address. My question is, is it
just a mistake in the assembler documentation that says that this LCALL
and LJMP is only good for the 56 and 57? I make the assumption that
it will work for the 58 too with 2k eprom? correct?
2. why isn't this instruction available for the new assembler
pasmx? Am I missing a common practice that works better?
3. I am just starting to look at the micro chip instruction set,
and wondering how do you get around this with this instruction set.
I'm definitely missing something here.
See also: www.piclist.com/techref/language/index.htm?key=asm
You must be a member of the
piclist mailing list
(not only a www.piclist.com member) to post to the