Searching \ for 'pic16pro programing software troubles' in subject line. ()
Make payments with PayPal - it's fast, free and secure! Help us get a faster server
FAQ page: www.piclist.com/techref/microchip/devices.htm?key=pic
Search entire site for: 'pic16pro programing software troubles'.

Truncated match.
PICList Thread
'pic16pro programing software troubles'
1999\03\30@060126 by Stuart O'Reilly

flavicon
face
Has anyone used the pic16pro software to program pics with a DT001
programer from dontronics? I am at the moment trying to use this setup
to program a 16C73a with no success. When I try to program the pic it
comes up with an error   0 287D 3FFF. I have the 16c73a mounted in a
PIC003 simmstick. I have now programed this pic in a professional
programer at work , now if i put the pic back into my pic003 simmstick
and try read it with the software the program space comes up with all FF
(but it reads ok at work). Has anyone come across this before???
Regards
Stuart

1999\03\30@163119 by Matthew Ballinger

picon face
>Has anyone used the pic16pro software to program pics with a DT001
>programer from dontronics? I am at the moment trying to use this setup
>to program a 16C73a with no success. When I try to program the pic it
>comes up with an error   0 287D 3FFF.

       I once used the software and a homemade programmer and was getting the s
ame
errors you are getting. I could find no fault with the hardware. The error I
got only came intermittently though. In most cases it worked great. When I did
get the fault I had to restart the program a few times before it would work
again. I never figured out what the problem was however. Hopefully someone out
there can help us.
Matt


'pic16pro programing software troubles'
1999\04\02@025450 by Dr. Imre Bartfai
flavicon
face
Hi,

I could not persuade my homemade programmer for PIC16PRO to work unless I
put two 330 pF condensers between RB.7 - GND and RB.6 - GND, respectively.
Now it works fine. However, in some cases, the ISP does not work, such way
I made a small programming breadboard. Now everything is fine.

Imre


On Tue, 30 Mar 1999, Matthew Ballinger wrote:

> >Has anyone used the pic16pro software to program pics with a DT001
> >programer from dontronics? I am at the moment trying to use this setup
> >to program a 16C73a with no success. When I try to program the pic it
> >comes up with an error   0 287D 3FFF.
>
>         I once used the software and a homemade programmer and was getting the
same
> errors you are getting. I could find no fault with the hardware. The error I
> got only came intermittently though. In most cases it worked great. When I did
> get the fault I had to restart the program a few times before it would work
> again. I never figured out what the problem was however. Hopefully someone out
> there can help us.
> Matt
>
>

More... (looser matching)
- Last day of these posts
- In 1999 , 2000 only
- Today
- New search...