Searching \ for 'Watchdog Timer and testing' in subject line. ()
Make payments with PayPal - it's fast, free and secure! Help us get a faster server
FAQ page:
Search entire site for: 'Watchdog Timer and testing'.

Truncated match.
PICList Thread
'Watchdog Timer and testing'
1999\10\26@180218 by Dwornik, Sebastian

So you have completed your design, and now comes the testing.
How do you test such a design to prove that the WDT is working

Do you zap the PIC with some electricity and see if it has regained
control correctly?
Flood it with intense noise that is sure to freak out some of its

This is where a true hardware ICE probably comes into play (for those
that can afford them).

In addition, can someone explain the drift with regards to temperature
that a WDT on
a PIC (eg. 16F84) can have?  I would like to understand more of it and
eventually incorporate
the WDT usage in my designs, but not if its too unstable.

Reliability is the key here.


- Sebastian

> {Original Message removed}

1999\10\26@190548 by Alice Campbell

Well, OK, how about a temporary test circuit:  set a momentary contact
switch on an input pin.  Write a btfss debounce loop to read the pin
without a CLRWDT in it (light up an led or beep something to
confirm).  Prescale the WDT to max.  Fire up the circuit, and tap the
button.  the light should flash.  Now restart, and hold down the
button.  Because there is no CLRWDT, the thing will crash and

For more entertainment, write a loop for a 2-minute sleep delay.
Measure delay with stopwatch.  Now, using hair dryer, heat up the
circuit and measure the same delay.  Then move outdoors, and stand
outside shivering in the dark for half an hour and measure the sleep
delay again.  There are resistive elements in the pic, and resistors
change resistance with temperature.


{Quote hidden}

> > {Original Message removed}

More... (looser matching)
- Last day of these posts
- In 1999 , 2000 only
- Today
- New search...