Post by thread:Programmer for pic16f873

Oscar wrote: > > Hello > Is there any programmer (with software for dos/w95) that you can bulid > that support pic16f873? DT001 SimmStick Programmer Kit. As well as being a full PICmicro development platform, this programmer has a 4PDT switch which allows you to program a PIC16F87x in a SimmStick and run the program straight away. Yes, a load and go operation. This means you don't have to move the PIC16F873 chip from the programmer to a target board as they are one and the same. LOAD/RUN. Straight away!! http://www.dontronics.com/pickaxe.html http://www.dontronics.com/dt001.html http://www.dontronics.com/dt106.html DIY KIT-96 Serial PIC Programmer. This 8, 18, 28 & 40 pin PICmicro programmer Kit runs off the Parallel Printer Port of a PC. http://www.dontronics.com/diyk96.html P16PRO Software Registration for the above three kits. (PIC16F84 software is free) http://www.dontronics.com/p16pro.html DIY KIT-117 KIT. PICALL Serial PIC Programmer. This 8, 18, 28 & 40 pin PICmicro programmer Kit runs off the Parallel Printer Port of a PC, programs the PIC16C54, PIC16C55, PIC16C56, PIC16C57, and the PIC16C58, as well as all other PICmicro chips in the PIC16PRO range. It includes a programmed chip, and no software registration is required. As well as the vast range of PICmicro devices, the PICALL hardware kit can also program ATMEL AVR micros AT90S12000, AT90S2313, AT90S4414 and AT90S8515's. http://www.dontronics.com/picall.html Don McKenzie spam_OUTdonTakeThisOuTdontronics.com http://www.dontronics.com World's Largest Range of Atmel/AVR and PICmicro Hardware and Software. Free Basic Compiler and Programmer http://www.dontronics.com/runavr.html