> Hey
>
> I'm building a Linux PC (for PIC and 'net stuff) and have an old hard
> drive
> for it but no docs :-(
>
> I know it's a 540Meg and the drive params for CMOS, but that's about
> it.
> It works as the slave drive to another Conner, but for a master I
> don't
> have any jumpers to configure it.  There aren't any jumpers on the
> board!
>
> Anybody have info on how to make a Conner CFA540A drive act as the
> Master
> (Actually, ONLY) drive?  Right now I get HD Controller Failures.
>
> Thanks a BUNCH!
>
> Andy
>
> ==================================================================
> Andy Kunz - Montana Design - 409 S 6th St - Phillipsburg, NJ 08865
>           Hardware & Software for Industry & R/C Hobbies
>         "Go fast, turn right, and keep the wet side down!"
> ==================================================================