Post by thread:16F84 programmer for NT?

Hi people! I've built one of the very simple com port driven pic programmers (16C84, F84), and it has worked very well. The trouble is that the software only works in dos/win3 or win 95. Are there any software for any (free) programmer that works in NT? Lpt or com port doesn't matter. -Henrik

On Sun, 14 Dec 1997 17:18:23 +0100, you wrote: >Dear HENRIK LEAWANDER, I think You neea a SENTINEL driver for your NT. >NT 3.51 or 4.0 is detached fron LPT1 port to prevent hang. Bye Ciao Ok, sounds good but but what is it? Do you know where can I get it? -Henrik

>I've built one of the very simple com port driven pic programmers (16C84, >F84), and it has worked very well. The trouble is that the software only >works in dos/win3 or win 95. Are there any software for any (free) >programmer that works in NT? Lpt or com port doesn't matter. Not free, but works well - I use it myself. http://www.carmacon.com They have an upgrade for the Parallax programmer that works under NT. Andy ================================================================== Andy Kunz - Montana Design - 409 S 6th St - Phillipsburg, NJ 08865 Hardware & Software for Industry & R/C Hobbies "Go fast, turn right, and keep the wet side down!" ==================================================================