Post by thread:[SX] Quick questions about SX KeyRing...

In SX Microcontrollers, SX/B Compiler and SX-Key Tool, robotworkshop wrote:Hello, I just received my SX KeyRing this morning and had a few questions about it: 1 - It appears that the silkscreen is backwards where the SX-Key plugs in. I can follow the traces and used an ohm meter to confirm that I should not reference the silkscreen and the component side of the SX-Key should be up instead of what the silkscreen shows. 2 - The connector looks like it is center + and the outside GND. Can someone confirm the specs for the power adapter? 3 - Was there a datasheet online just for the SX KeyRing? There no longer seems to be any reference on the Parallax site for it.

Robert ---------- End of Message ---------- You can view the post on-line at: http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=206287 Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)

In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Peter Van der Zee wrote:Hi Robert; 1. You are absolutely correct. 2. Correct again. I use a 9-ish volt center positive wall wart. Works fine. 3. Can't help you here.

Cheers, Peter (pjv) ---------- End of Message ---------- You can view the post on-line at: http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=206287#m206553 Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2007 (http://www.dotNetBB.com)