Searching \ for '[PIC] Measuring Analogue Voltages w/o Sharing Grou' in subject line. ()
Make payments with PayPal - it's fast, free and secure! Help us get a faster server
FAQ page: www.piclist.com/techref/microchip/ios.htm?key=analog
Search entire site for: 'Measuring Analogue Voltages w/o Sharing Grou'.

Exact match. Not showing close matches.
PICList Thread
'[PIC] Measuring Analogue Voltages w/o Sharing Grou'
1999\10\28@152009 by Richard Prosser

flavicon
face
As an addendum to the differential A/D and instrumentation amplifiers, and
depending on the precision you require, a standard differential amplifier
using 1,2 or three opamps could be used. As the "common" ground connection
is taken as being a low impedance source, the single op-amp config may well
be adequate. In this configuration run the "common" side to the inverting
input and the "signal" side to the non-inverting input. Common mode error (&
l.f. noise rejection) will  be mainly determined by resistor matching so us
1% or better if you need useful accuracy. This will limit any current loops
to the values determined by your input resistors.
If you need better isolation a double op-amp config will give you high input
Z but somewhat limited common mode range. 3 op-amp will give you best
performance overall - but at the expense of realestate.
Suggested opamp - OP177 for low DC drift & offset (I think a quad pack
version is also available now)


Richard P

> {Original Message removed}

More... (looser matching)
- Last day of these posts
- In 1999 , 2000 only
- Today
- New search...