Post by thread:[PIC]:PCLATH still not working..code review?]

ok..took another few stabs, and made maybe progress of a sort. I forced the entire code to run in the second page, and it works. SO that means that at least the hardware/chip/software is doing something right. But even after reviewing the comments, I still cannot get it to bounce back and forth between pages. Next will be a simpler turn on an LED from the other page...baby steps.. ____________________________________________________________________ Get free email and a permanent address at http://www.netaddress.com/?N=1 -- http://www.piclist.com hint: PICList Posts must start with ONE topic: [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads

>But even after reviewing the comments, I still cannot get it to bounce back >and forth between pages. > >Next will be a simpler turn on an LED from the other page...baby steps.. If you're really sure it's the PCLATH thing (it could be something else, you know) how about you "rig" the experiment so that no matter which page you "return" to, you land on top of executable code? Then have each one flash a different signal to tell you where you actually landed. "Rigged", if you're not used to it, in this case means using ORG's and whatever else to force certain pieces of code to exist at certain predetermined addresses. Barry -- http://www.piclist.com hint: PICList Posts must start with ONE topic: [PIC]:,[SX]:,[AVR]: ->uP ONLY! [EE]:,[OT]: ->Other [BUY]:,[AD]: ->Ads