Searching \ for '[EE] Eagle question (How to Auto Place Components' in subject line. ()
Help us get a faster server
FAQ page: www.piclist.com/techref/pcbs.htm?key=eagle
Search entire site for: 'Eagle question (How to Auto Place Components'.

Exact match. Not showing close matches.
PICList Thread
'[EE] Eagle question (How to Auto Place Components '
2004\12\27@163307 by o Yipmantin

2004\12\27@172901 by Rob Young

>I will be very pleased if anyone can tell me how to AUTO PLACE
> components in a Eagle V. 4.03 board.
>
> Regards,
>
> Augusto
>
Go to http://www.cadsoftusa.com and browse around until you find the downloads
section and the collection of ULPs.  There are a couple of different
auto-place ULPs.  I've tried them and I wasn't all the impressed.  I place
all my boards manually.  Then I route critical traces manually.  If the
board is small (2 layers and less then 50 parts typically) I just route all
by hand otherwise I let the autorouter have a crack at it.  But then I need
to go back through and clean up some of its nonsense.

There are a few autorouter packages out there that can deal with Eagle
boards.  Check out the Eagle/Cadsoft newsgroups.  Again I reference you to
http://www.cadsoftusa.com for more information on the newsgroups.

Rob Young
spam_OUTrwyoungTakeThisOuTieee.org

2004\12\27@173919 by olin_piclist

More... (looser matching)
- Last day of these posts
- In 2004 , 2005 only
- Today
- New search...