NLSFUNC + Selecting Code Pages with CHCP
Allows you to select code pages (character sets) with the
CHCP (change code page) command.
[d:][path] NLSFUNC [fd:][fpath][COUNTRY.SYS]
[d:][path] Specifies the drive
letter and path that
contain the NLSFUNC
[fd:][fpath][COUNTRY.SYS] Specifies the drive
letter and path of the
COUNTRY.SYS file. Use
only if this file is not
located in the current
NLSFUNC allows you to use the CHCP command to select
additional character sets (code pages).
loads the NLSFUNC command, using the COUNTRY= command as defined
in the CONFIG.SYS file.
loads the NLSFUNC command while specifying that the COUNTRY.SYS
file is stored in a directory named SPEC on drive C.
NLSFUNC must be loaded before you use the CHCP command to
change code pages.
[For related topics, press R]
|file: /Techref/dos/command/nlsfunc.htm, 1KB, , updated: 1999/2/20 10:24, local time: 2018/1/22 06:52,
|©2018 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?|
<A HREF="http://www.piclist.com/techref/dos/command/nlsfunc.htm"> dos command nlsfunc</A>
|Did you find what you needed?|
PICList 2018 contributors:
o List host: MIT, Site host massmind.org, Top posters @20180122 David C Brown, Isaac M. Bavaresco, Manu Abraham, RussellMc, Van Horn, David, Dwayne Reid, Harold Hallikainen, James Cameron, Sean Breheny, John Gardner,
* Page Editors: James Newton, David Cary, and YOU!
* Roman Black of Black Robotics donates from sales of Linistep stepper controller kits.
* Ashley Roll of Digital Nemesis donates from sales of RCL-1 RS232 to TTL converters.
* Monthly Subscribers: Gregg Rew. on-going support is MOST appreciated!
* Contributors: Richard Seriani, Sr.
Welcome to www.piclist.com!