Paul T Barton Says:
For now and since about 2010, I have been building LED cubes using PIC 18F4321 chips (TQFP and DIP-40). I have a pile of sub-routines related to the editing portion of these cubes. I tie the serial port to USB through a teensy USB PCB. Editing is the heavier portion of these cubes as I tend to believe in creaping-featureitis. If any of you would like to see some of those routines, holler back. For now I only use mono LEDs or two-color (Red/Green) LEDs.+
Paul T Barton Says:
As to the hardware, I am using CAT4016 cathode-sink shift-registers (16 bit wide) and P-channel FETs (IRF7306) for layer/anode drivers. This means that most of the LEDs are common cathode ones (so far). Biggest so far is 8x8x8 green and smallest is 2x2x2 yellow while I have one made up of SMD-1206 LEDs. I have a couple of u-tube clips under the name "IdeZilla".+
file: /Techref/member/pTB-OOSN-W41/index.htm, 1KB, , updated: 2017/4/11 20:09, local time: 2024/4/24 23:24,
owner: pTB-OOSN-W41,
3.145.163.58:LOG IN
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://www.piclist.com/Techref/member/pTB-OOSN-W41/index.htm"> Member Homepage for pTB-OOSN-W41</A> |
Did you find what you needed? |